Equipment
Fabrication
Shears, Power Squaring (Gauge)
Cidan Rapido 32 Shear 126" x 13 GA

Cidan Rapido 32 Shear 126" x 13 GA

Have one to sell?
(800) 721-9793
info@norcalmachinery.com
Have one to sell?

Document (1)

Cidan_Rapido_Flyer.pdf

Overview

Type:
Shears, Power Squaring (Gauge)
Manufacturer:
CIDAN
Model:
RAPIDO 32
Status:
For Sale

Description

The CIDAN RAPIDO is an electrical guillotine shear that works fully independent of oil or hydraulics and offers manual use of the hand wheel system, drive system with eccentrics and pull-down rod, and standard squaring arm and table extension for multiple sheets.

Max Gauge13 gauge13 gauge
Length of Blade126"3,200.4 mm
Hyd/MechMechMech
Back Gauge29.5"749.3 mm
Power4 hp3 kW
SPM37 strokes/min.37 strokes/min.
ControlCNC (CutLink)CNC (CutLink)

Suggested Blog Posts

New Saw Purchase

Mar 26, 2024 | Steve Humphries

The Sawing Expert SeriesBy Larry Anderson, Technical Advisor Saws are sold by salesmen who generally know their product and customers have a need that can be filled by purchasing a new saw from a well prepared salesman. Customers must always stay focused on their needs and also try to plan for an uncertain future. S...

Resolving Crooked Cuts - Lesson #6

Mar 26, 2024 | Steve Humphries

By Larry Anderson Technical AdvisorAnalyzing Issues Related To The Blade:1. A dull blade will generally cut crooked. 2. A blade should be discarded if the cut time grows by more than 50%. For instance: 20 cuts have been made and the cut time has been 10 minutes per cut. Without making any other adjustments and the c...

Resolving Crooked Cuts Lesson #5

Mar 26, 2024 | Steve Humphries

Larry Anderson Technical Advisor In Lessons 1 through 4 we have examined the saw. Now we should make a trial cut with very conservative settings to see if the crooked cut can be duplicated. A two inch (2”) round cold roll would be perfect, but then again a four inch (4”) square tube is easier to measure for squaren...

Resolving Crooked Cuts Lesson #3

Mar 26, 2024 | Steve Humphries

By Larry Anderson Technical Advisor The crooked cut problem has not been solved and we have checked for loose guides and guide arms that are not square to bed of the saw and found that this is not the problem. We have yet to remove the blade from the saw and it is time to think about tension.Analyze Blade TensionI...

Resolving Crooked Cuts Lesson #2

Mar 26, 2024 | Steve Humphries

By Larry Anderson Technical AdvisorAfter examining the blade guides and determining the jaw blocks are tight, we can move on to the next possibility. Guide Arm Squareness: Take a small scrap of steel 1/4" thick six inched long and clamp it to the blade so the six inches is straight vertical attached to blade. Put sq...

Resolving Crooked Cuts Lesson #1

Mar 26, 2024 | Steve Humphries

The Sawing Expert Series By Larry Anderson. Resolving Crooked Cuts Lesson step #1. Larry, a metal sawing expert, walks our users through a series of steps to get square and straight cuts on your saw.

We use cookies to improve your experience. Privacy Policy.

Accept