LOCKFORMER SPIN COLLAR MAKER #6 | Roll Formers
Have one to sell?
New
Just cut galvanized stock (24 gauge & lighter) to width and length, set the diameter from 4" to 16", and push the blank against the automatic stop. A synchronized die notches the lead edge for easy spin-installation on the job site. The notched piece is then pushed past the stop, feeding the part into the roll former and finally into the automatic crimping and curling operations. Two models are available - Model 6 (2" to 6") and Model 12 (2" to 12").
Brand: Lockformer
Model: Duct Collar Maker Machine #6
Capacity: 24-30 gauge
Tab-Notch Depth and Spacing: Tab-notch depth 5/8″ standard, adjustable to 3/4″
Speed: 30 feet per minute
Motor / Voltage: 3/4 hp, 115 volt, single phase
Drive: V-belt
Dove Tail with Tabs allows you to notch, bead, crimp, and roll in one pass — saving you time and money. For complete round starting collars 3 to 14 inches in diameter out of 24-30 gauge galvanized steel, the Lockformer Duct Collar Maker is the perfect tool. Just cut to width and length or use scrap. This machine uses either 3″ or 6″ width blanks with simple movement of the crimp roll.
We use cookies to improve your experience. Privacy Policy.